Stealth Dimmer SP: Installation Instructions
	Chip Signals: Pin 1- +3.3 volts (Chip Power) Pin 2- Light Button Input Pin 3- "Darker" Input (B) Pin 4- "Brighter" Input (A) Pin 5- Sync Input Pin 6- Frontlight Output Pin 7- Frontlight Output Pin 8- Ground GBA-SP Button Signals: TP0- A TP1- B TP2- Select TP3- Start TP4- Right TP5- Left TP6- Up TP7- Down TP8- R TP9- L   Installation Tips: Do not take the GBA-SP screen apart; it is only necessary to disassemble the base Locate Pin 1 on the chip by looking for a dimple in one corner Stick the chip to the GBA board using double-sided tape first so it won't move around while soldering Cut off excess wire length Use low-wattage, fine-tipped soldering iron Use flux or rosin-core solder Don't hold the iron on the chip pins too long as you could damage the chip Don't hold the iron on the GBA board too long as you may lift the solder pad Make sure wires don't cross white areas, screw holes, or tall components If alternate button assignments are desired, see button signal list for available connection points

Copyright © 2002-2008 Division 6