Stealth Dimmer v4: Installation Instructions
	GBA Button Signals: TP0- A TP1- B TP2- Select TP3- Start TP4- Right TP5- Left TP6- Up TP7- Down TP8- R TP9- L Chip Signals: Pin 1- +3.3 volts (Chip Power) Pin 2- "Enable" Input (Select) Pin 3- "Darker" Input (B) Pin 4- "Brighter" Input (A) Pin 5- Sync Input Pin 6- AB Out (-) Pin 7- AB Out (-) Pin 8- Ground Installation Tips: Locate Pin 1 on the chip by looking for a dimple in one corner Stick the chip to the GBA board using double-sided tape first so it won't move around while soldering Cut off excess wire length Use low-wattage, fine-tipped soldering iron Use flux or rosin-core solder Don't hold the iron on the chip pins too long as you could damage the chip Don't hold the iron on the GBA board too long as you may lift the solder pad Don't connect a wire directly from Afterburner (-) pad to GND on the GBA board (as shown in Afterburner manual). This could damage the chip If alternate button assignments are desired, see button signal list for available connection points

Copyright © 2002-2008 Division 6